Analysis of five installation methods of the hotte

  • Detail

Analysis of five installation methods of LED display screen

due to the particularity of its products, the installation and debugging process of LED display screen often reflects the product quality and also determines the effect of the display screen in use. Therefore, the installation and debugging of LED display screen is a very important technical work. Here, five installation methods commonly used in the LED screen industry are compiled:

extensometer is a sensor for measuring the deformation of test pieces, It is mainly used for the performance indicators corresponding to the small deformation of the sample, such as the specified non proportional extension strength and elastic modulus measured by the impact tester. If these items do not need to be measured, it is not necessary to install the extensometer

1 Inlay installation: suitable for indoor screen with small area. Due to the small installation space, in order not to occupy space, our experimental machine price, quality, service, 3 guarantee according to the screen area, dig out the same size area on the wall, and embed the LED display screen into the wall. The wall is required to be solid. The cost of pre maintenance is high

2. Wall mounted installation: it is mostly suitable for the installation of indoor LED display screens, with a small area (less than 10 square meters). The wall is required to be a solid wall, and hollow bricks or simple partition walls are not suitable for this installation method

3. Hanging installation: it is mostly suitable for station LED electronic display screen, airport LED electronic display screen and other large places to play the role of indicator signs. Small screen area is required. (less than 10 square meters) it is required to have a suitable installation location, such as a beam or lintel above, and the screen body generally needs to be covered with a back cover

4. Column type installation: it is mostly used for the installation of outdoor advertising LED electronic display screen. It has a wide field of vision and is located in relatively open places, such as squares, parking lots, etc. According to the size of the screen area, it can be divided into single column and double column installation. The experiment was carried out according to the specified procedure

5 Roof mounted installation: it is mainly applicable to outdoor advertising LED electronic display. The installation location is mainly the roof of the building. With the increase of the height of the building, the wind protection level to be considered will also increase

Copyright © 2011 JIN SHI